This 12.1″ colour LCD monitor replaces the original 12″ colour CRT monitor that was fitted to the Fadal CNC 88HS and Fadal VMC2016L.
The original CRT monitor uses a single BNC connector for the video signal, as shown in this image. Our replacement LCD uses the same type of BNC connector to allow you to use the existing video cable in your machine.
BNC video connector on the original CRT monitor.
For the power connection we provide a rewirable IEC (Kettle type connector) which is simply wired to the 110VAC feed that was used to power the original CRT monitor.
- Original Display: Fadal CNC 88HS, Fadal VMC2016L, Model 914, Omni Vision LP1215HVN 12″ colour CRT monitor
- Replacement Display: 12.1″ TFT Full Colour active LCD, 800 x 600 pixels
- Active Display Area: 246.0 x 184.5 mm (equivalent to 12″ CRT)
- Frequency: 15-45 kHz horizontal, 50-75 Hz vertical
- Display Settings: via OSD (on Screen Display
- Controller: FADAL CNC 88HS
- Video connector: 1 x BNC
- Input power: 85-240 VAC via IEC (kettle) connector
- Standards: CE industry certified, EN55022, EN55024